Please note the following instructions regarding the gluing of our four new rubbers onto the blade:
Dr Neubauer GORILLA and BOOMERANG CLASSIC Please do not use any glue containing solvents. These glues have been banned by ITTF. Also they affect the playing characteristics negatively. Solvents increase the speed of the rubber decisively. This results in a decrease of disruptive effect and control.
Gluing instructions: Please apply glue without any solvent (such as our 'Contact Glue') onto the blade and onto the sponge of the rubber. Let it dry approximately 10 minutes and then put the rubber onto the blade carefully.
In case you only have a glue with solvent at your disposal: Put a layer onto the blade. Then put a very thin layer of glue onto the sponge. Let it dry for approximately 10 minutes and then put the rubber onto the blade. After this the bat needs to be aired for about 24 hours before first use. We hereby inform you explicitely that the use of glues containing solvents is not allowed according to current ITTF regulations. Any use of such glue is at your own risk.
Dr Neubauer GRIZZLY and MONSTER CLASSIC Put a layer of glue without solvent (such as our 'Contact Glue') onto the blade and let it dry for about 10 minutes. Then take off the white protection sheet at the back of the rubber to unveil the sticky glue sheet. Put the rubber (with the sticky glue sheet) carefully onto the blade.
Of course please don't hesitate to contact us for any further questions.